Enlarge / The power adapter for the RTX 4090 feeds four 8-pin power connectors into a single 12VHPWR connector. (credit: Sam Machkovech)
Earlier this week, a couple of Reddit users reported that the power connectors for their expensive new Nvidia GeForce RTX 4090 GPUs had partially melted and that Nvidia was looking into the issue. Since then, at least nine additional Reddit users have posted about the same problem with the 16-pin power connector (a thread collecting all information on the problem is here).
Igor Wallossek of the German-language hardware site Igor's Lab has also performed additional testing, and said that the power adapter cable (rather than the GPUs or the 12VHPWR connector) may be to blame for the problems. The adapter, which is apparently manufactured by a company called Astron and was provided by Nvidia to all of its board partners, uses "a total of four thick 14AWG wires distributed over a total of six contacts," with a thin solder base that Wallossek says can be damaged easily when the cables are moved or bent.
The solder inside of Nvidia's power adapter cable can be damaged if the cables are moved or bent too much. (credit: Igor's Lab)
"If, in the worst case, the two outer wires break off, the entire current in the middle flows through the remaining two wires," Wallossek wrote. "The fact that this then becomes really hot does not have to be explained separately."
Read 2 remaining paragraphs | Comments
Enlarge / The power adapter for the RTX 4090 feeds four 8-pin power connectors into a single 12VHPWR connector. (credit: Sam Machkovech)
Earlier this week, a couple of Reddit users reported that the power connectors for their expensive new Nvidia GeForce RTX 4090 GPUs had partially melted and that Nvidia was looking into the issue. Since then, at least nine additional Reddit users have posted about the same problem with the 16-pin power connector (a thread collecting all information on the problem is here).
Igor Wallossek of the German-language hardware site Igor's Lab has also performed additional testing, and said that the power adapter cable (rather than the GPUs or the 12VHPWR connector) may be to blame for the problems. The adapter, which is apparently manufactured by a company called Astron and was provided by Nvidia to all of its board partners, uses "a total of four thick 14AWG wires distributed over a total of six contacts," with a thin solder base that Wallossek says can be damaged easily when the cables are moved or bent.
The solder inside of Nvidia's power adapter cable can be damaged if the cables are moved or bent too much. (credit: Igor's Lab)
"If, in the worst case, the two outer wires break off, the entire current in the middle flows through the remaining two wires," Wallossek wrote. "The fact that this then becomes really hot does not have to be explained separately."
Read 2 remaining paragraphs | Comments
October 29, 2022 at 03:22AM
Post a Comment